This page contains real-time data from the BLANkET air station at Lilydale (North-Eastern Tasmania) for today and yesterday. The Lilydale station is approximately 1 km from the town centre, however, on calm winter nights domestic woodsmoke from the town can impact on the measurements by flowing down the small valley to the station.
Current air quality at Lilydale
Date: 17 June 2021 Time: 19:02 AEST (add one hour for summer time)
Current PM10 = 2 micrograms per cubic metre
Current PM2.5 = 0 micrograms per cubic metre
Hour-average PM2.5 = 0 micrograms per cubic metre
Air quality health category (from the hour-average PM2.5) is good
The plots below show PM10 and PM2.5 indicative data (top) and meteorological data (bottom) measured today at Lilydale. The most recent measurements are shown in the boxes to the right of the plots below.
T - air temperature
RH - relative humidity
WS - wind speed
WD - wind direction
RF - daily rainfall
P - mean sea-level pressure (MSLP)
The meteorological data are provided as a guide to interpreting the air quality data. They should not be used in place of Bureau of Meteorology data for determining weather conditions in a given region.
Please Note: subject to network connectivity, this plot will be updated approximately every 10 minutes during the day. Use the 'Refresh' or 'Reload' button on your browser (or press F5) to refresh the plot. If networking issues do not allow real-time access on a given day the plot will show the most recently available data.
More information about interpreting the plots
Air quality health categories
The Tasmanian Department of Health provides the following air quality health categories based on the hour-averaged PM2.5 value:
Good: 0 to 9 micrograms per cubic metre
Fairly Good: 10 to 24 micrograms per cubic metre
Fairly Poor: 25 to 49 micrograms per cubic metre
Poor: 50 to 99 micrograms per cubic metre
Very Poor: 100 to 299 micrograms per cubic metre
Extremely Poor: Over 300 micrograms per cubic metre
See the Department of Health Track Air Quality page for more information (scroll to the bottom of the page for category information).
Yesterday's data from Lilydale BLANkET station
The plots below show PM10 and PM2.5 indicative data (top) and meteorological data (bottom) measured yesterday at Lilydale (North-East Tasmania). The day-average measurements are shown in the boxes to the right of the plots below.
We would like to acknowledge the support of Launceston City Council for assisting in the installation and operation of the station.
Data for this station for other time intervals (including previous years) can be accessed from the Access historical BLANkET data page.
Please Note: if network connectivity has prevented remote access to the station the plot will show the most recently available complete day of data.