This
page contains real-time data from the BLANkET air station at Perth
(Northern Midlands, Tasmania) for today and yesterday. The Perth
station is approximately 500 m north of the town
centre.
Current air quality at Perth
Date: 26 September 2020 Time: 04:14 AEST (add one hour for summer time)
Current PM10 = 6 micrograms per cubic metre
Current PM2.5 = 5 micrograms per cubic metre
Hour-average PM2.5 = 15 micrograms per cubic metre
Air quality health category (from the hour-average PM2.5) is Fair
The plots below show PM10 and PM2.5 indicative data (top) and meteorological data (bottom) measured today at Perth. The most recent measurements are shown in the boxes to the right of the plots below.
Key:
T - air temperature
RH - relative humidity
WS - wind speed
WD - wind direction
RF - daily rain fall
P - mean sea-level pressure (MSLP)
The meteorological data are provided as a guide to interpreting the air quality data. They should not be used in place of Bureau of Meteorology data for determining weather conditions in a given region.
Please Note: subject to network connectivity, this plot will be updated approximately every 10 minutes during the day. Use the 'Refresh' or 'Reload' button on your browser (or press F5) to refresh the plot. If networking issues do not allow real-time access on a given day the plot will show the most recently available data.
More information about interpreting the plots
Air quality health categories
The Tasmanian Department of Health provides the following air quality health categories based on the hour-averaged PM2.5 value:
Good: up to 10 micrograms per cubic metre
Fair: 10 to 25 micrograms per cubic metre;
Poor: 25 to 100 micrograms per cubic metre
Very poor: over 100 micrograms per cubic metre.
See the Department of Health Track Air Quality page for more information (scroll to the bottom of the page for category information).
Yesterday's data from Perth BLANkET station
The plots below show PM10 and PM2.5 indicative data (top) and meteorological data (bottom) measured yesterday at Perth (Northern Midlands, Tasmania). The day-average measurements are shown in the boxes to the right of the plots below.
We would like to acknowledge the support of the Northern Midlands Council
for assisting in the installation and operation of the station.
Historical data
Data for this station for other time intervals (including previous years) can be accessed from the Access historical BLANkET data page.
Please Note: if network connectivity has prevented
remote access to the station the plot will show the most recently
available complete day of data.
